HIVEC Inhibit Conditions
WARNING: This page is about a different variant/trim than selected.
- ATF temperature below 40°C.
- When standard pattern is not used.
- Inhibitor switch: P, R, N, L
- Extremely low temperature mode
- Lower emission shift pattern
- ATF control variable shift pattern
- During fail safe mode (3rd gear hold)
- In case of prohibition of Intelligent shift
- TPS faulty (Short: P1702, Open: 1701)
- ATF Temperature sensor faulty (P1712)
- Stop lamp s/w faulty (P0703)
- TCM faulty (Check engine lamp ON)
- After IG ON until first time stop lamp S/W comes ON-->OFF.