LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tiburon SE >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA-GSL 2.7L) >> DTC Troubleshooting Procedures >> DTC P0118 Engine Coolant Temperature Circuit High Input >> Component Inspection

Component Inspection

  1. Ignition "OFF"
  2. Measure resistance between terminals 1 and 3 of the ECT sensor connector (Component side)

    Specification:

    ECTS RESISTANCE SPECIFICATION

    Temperature Resistance(kΩ)
    20°C(68°F) Approx. 2.31 ~ 2.59
    40°C(104°F) Approx. 1.15
    80°C (176°F) Approx. 0.32
    Fig 1: Measuring Resistance Between Terminals 1 And 3 Of ECT Sensor Connector (Component Side)
    G03849444Courtesy of HYUNDAI MOTOR CO.
  3. Is resistance within the specification?

    YES: 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

    • Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals