LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tiburon SE >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Alternator >> Removal >> 2.7 V6 Engine

2.7 V6 Engine

  1. Disconnect the battery negative terminal first then the positive terminal.
  2. Loosen the drive belt tension adjusting bolt, then remove the drive belt (A).
  3. Disconnect the connector (A) and "B" terminal cable (B).
    Fig 1: Disconnecting Connector And "B" Terminal Cable
    G03849045Courtesy of HYUNDAI MOTOR CO.
  4. Pull out the through bolts (A) and nuts (B) then remove the generator (C).
    Fig 2: Pulling Out Through Bolts, Nuts And Generator
    G03849046Courtesy of HYUNDAI MOTOR CO.
  5. Installation Is Reverse Of Removal.
    NOTE:
    • Adjust The Generator Belt. (Refer To ALTERNATOR BELT INSPECTION AND ADJUSTMENT )
    • Place The Alternator And Insert A Support Bolt (Do Not Insert A Nut This Time).
    • After Pushing The Alternator Forward, Count That How Many Spacers (A Spacer Thickness: 0.198 Mm) Should Be Inserted Between The Alternator Front Leg And Front Case As Shown In "A".
    • After Inserting Spacers, Insert And Tighten A Nut Securely.
    Fig 3: Identifying Spacer Thickness
    G03849047Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals