LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Santa Fe SE, FWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer Control System >> Immobilizer Control System >> DTC P1675 Transponder Programming Error >> Monitor DTC Status

Monitor DTC Status

  1. Connect scan tool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF".
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC B1675 present?

    YES 

    Go to "Inspection and Repair" procedure.

    NO 

    Fault is intermittent caused by poor contact in SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals