LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Santa Fe GLS, FWD, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer Control System >> Immobilizer Control System >> DTC P1676 SMARTRA Message Error >> Monitor DTC Status

Monitor DTC Status

  1. Connect scantool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF".
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC B1676 present?

    YES 

    Go to "Inspection and Repair" procedure. .

    NO 

    Fault is intermittent caused by poor contact in SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals