LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Santa Fe GLS, AWD, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6EA-GSL 2.7) >> Gasoline Engine Control System >> ECT (Electronic Throttle Control) System >> Inspection >> Component Inspection >> Throttle Position Sensor (TPS)

Throttle Position Sensor (TPS)

  1. Connect a scantool on Diagnosis Link Connector (DLC).
  2. Start engine and check output voltages of TPS 1 and 2 at C.T and W.O.T.
    VOLTAGE CONDITION CHART

    Condition Output Voltage (V)
    TPS 1 TPS 2
    C.T 0.25 ~ 0.9V Min. 4.0V
    W.O.T Min. 4.0V 0.25 ~ 0.9V
  3. Turn ignition switch OFF and disconnect the scantool from the DLC.
  4. Disconnect ETC module connector and measure resistance between ETC module terminals 4 and 1 (TPS 1).
  5. Measure resistance between ETC module terminals 7 and 6 (TPS 2).
    Fig 1: Measuring Resistance Between ETC Module Terminals 7 And 6
    G05348872Courtesy of HYUNDAI MOTOR CO.

    Specification: Refer to SPECIFICATION .

scientia non olet · About LEMON Manuals