LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Santa Fe GLS, AWD, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> ESC (Electronic Stability Control) System >> Esp/ESC System >> Communication With Scan Tool Is Not Possible. (Communication With ABS Only Is Not Possible) >> Inspection Procedures >> Check The Power Source Of ESC Control Module

Check The Power Source Of ESC Control Module

  1. Disconnect the connector from the ESC control module.
  2. Turn the ignition switch ON, measure the voltage between terminal 28 of the ESC control module harness side connector and body ground.

    Specification: approximately B+

    Is voltage within specification?

    YES 

    • Check for poor ground.

    NO 

    • Check the harness or connector between the fuse (10A) in the engine compartment junction block and the ESC control module. Repair if necessary.
      Fig 1: Measuring Voltage Between Terminal 28 Of ESC Control Module Harness Connector And Body Ground
      G05350725Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals