Signal Circuit Inspection

Check voltage
1. IG "OFF" and disconnect ECTS connector.
2. IG "ON" and ENG "OFF"
3. Measure voltage between terminal 3 of ECTS harness connector and chassis ground.
  Specification : Approx. 5V
4. Is the measured voltage within specification ?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Go to " 2Check short to ground in harness" as follows.
Check short to ground in harness
1. IG "OFF" and disconnect ECTS connector and PCM connector.
2. Measure resistance between terminal 3 of ECTS harness connector and chassis ground.
3. Measure resistance between terminals 1 and 3 of ECTS harness connector.
  Specification : Infinite
4. Is the measured resistance within specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair short to ground in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.