Monitor DTC Status

Check DTC Status
1. Connect scantool to Data Link Connector (DLC).
2. IG "ON".
3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F4 (DTAL) to check DTC's information from the DTCs menu.
4. Read "DTC Status" parameter.
  
  Fig 1: Scantool Display - DTC Status" Parameter
  Courtesy of HYUNDAI MOTOR CO.
5. Is parameter displayed "Present fault"?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Fault is intermittent, go to "VERIFICATION OF VEHICLE REPAIR " procedure.