Handling Errors
- If errors are discovered, regard them as harness disconnection or sensor failure, and conduct the following measures.
- Stop auto control (play or Easy access function operation) if it is under auto control and set off buzzer 10 times (however, have motors other than the one with an error operate normally).
- Set off alarm again in case of recurrence of error after restoration of a motor with an error.
- Complete alarm 10 times though it comes back to normal during error alarm.
- Stop alarm if receiving memory recall or play order, and set off buzzer in the corresponding function.
- Manual operation control is allowed even for a motor with errors.
- Set off buzzer if memory or play order is received even during error.
- The timing to lift auto control suspension is when repair for the failing motor is completed, and the criteria for the completion point are as follows:
- Seat: if signal input is normal with over 6 pulses within a sec. from position sensor of a motor with an error caused by manual switch.
- Adjust pedal: if there is change in input of over 3 LSB within 1 sec. from sensor by manual switch.