Power Circuit Inspection
- IG "OFF" and disconnect Cooling fan module connector.
- IG "ON" & ENG "OFF"
- Measure voltage between terminal 1 of Cooling fan module harness connector and chassis ground.
Specification: Approx. B+
- Is the measured voltage within specification
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check if cooling fan fuse is open or not installed.
- Check if cooling fan relay is not installed or faulty
- Check if the line between cooling fan relay and Cooling fan module is open.
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.