Ground Circuit Inspection
- IG "OFF" & ENG "OFF"
- Disconnect OTS connector and IG "ON"
- Measure voltage between terminal 1 of OTS harness connector and chassis ground.
- Measure voltage between terminals 1 and 2 of OTS harness connector.
Specification: Measurement "A" - Measurement `B' = Approx. below 200mV
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure
NO
- Repair or replace contact resistance or open in harness and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.