LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Accent GLS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle System (A4AF3)) >> Automatic Transaxle System >> DTC P0708 Transaxle Range Switch - Multi-Input >> Power Supply Circuit Inspection

Power Supply Circuit Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect "TRANSAXLE RANGE SWITCH" connector.
  2. Ignition "ON" & Engine "OFF".
  3. Measure voltage between each terminal of the sensor harness connector and chassis ground.

    Specification: Shown below

    VOLTAGE CHART

    TERMINAL (C11) 2 3 4 5 6 7 8 9 10 11 12
    SPECIFICATION 0V 12V 0V 0V 12V 0V 0V 0V 0V 0V 0V
    Fig 1: Measuring Voltage Between Terminal Of Sensor Harness Connector & Chassis Ground
    G04802069Courtesy of HYUNDAI MOTOR CO.
  4. Is voltage within specifications?

    YES  : --> Go to "SIGNAL CIRCUIT INSPECTION " procedure.

    NO  : --> Check for short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals