LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2006 >> Tiburon GS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Transaxle System (F4A42) >> DTC Troubleshooting Procedures >> DTC P0707: Transaxle Range Switch - Low Input >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to data link connector(DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "TRANSAXLE RANGE SWITCH" parameter on the scan tool.
    4. Fig 1: Monitoring "TRANSAXLE RANGE SWITCH" Parameter On Scan Tool
    G03849742Courtesy of HYUNDAI MOTOR CO.
  4. Move selector lever from "P" range to other range.
  5. Does "TRANSAXLE RANGE SWITCH" follow the reference data?

    YES: 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM(PCM)'s connector or was repaired and TCM(PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

scientia non olet · About LEMON Manuals