Signal Circuit Inspection

Check for open in signal circuit.
1. Ignition "OFF".
2. Disconnect PCM connector.
3. Measure resistance between terminals 3 of the FTPS harness connector and 33 of the PCM harness connector.
  Specification: Approx. 0Ω
  
  Fig 1: Measuring Resistance Between Terminals 3 Of FTPS Connector And 33 Of PCM Connector
  Courtesy of HYUNDAI MOTOR CO.
4. Is resistance within the specification?
  Yes:
  - Go to next step as below.
  No:
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check for short to ground in signal circuit
1. Measure resistance between terminal 3 of the FTPS harness connector and chassis ground
  Specification infinite
  
  Fig 2: Measuring Resistance Between Terminal 3 Of FTPS Connector And Chassis Ground
  Courtesy of HYUNDAI MOTOR CO.
2. Is resistance within the specification?
  Yes:
  - Go to next step as below.
  No:
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.