Component Inspection

Measure resistance between terminals 1 and 2 of the injector connector (Component side).

SPECIFICATION

TERMINALS RESISTANCE CHART

Injector		Normal Parameter At 20°C (68°F)
Coil Resistance	For SULEV Vehicle	13.1 ~ 14.5Ω
Coil Resistance	For Non-SULEV Vehicle	14.4 - 14.6Ω

Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Injector Connector

Courtesy of HYUNDAI MOTOR CO.

Is resistance within the specification?
Yes:
- Go to next step as below.
No:
- Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.