Control Circuit Inspection

Check for short to ground in control circuit.
1. Ignition "OFF".
2. Measure resistance between terminal 2 of the injector harness connector and chassis ground.
Specification: Infinite

Fig 1: Measuring Resistance Between Terminal 2 Of Injector Connector And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Is resistance within the specification?
Yes:
- Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
No:
- Repair open or short to ground in control harness and go to "VERIFICATION OF VEHICLE REPAIR " procedure.