Component Inspection
- Ignition "OFF"
- Disconnect OTS connector.
- Measure resistance between terminals 1 and 2 of OTS connector. (Component side)
SPECIFICATION
TERMINALS RESISTANCE CHARTTemp. (°C) Temp. (°F) OTS Resistance (kΩ) 20 68 2.16 ~ 2.78 40 104 0.99 ~ 1.21 80 176 0.26 ~ 0.32 - Is sensor switching properly?
Yes:
- Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
No:
- Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.