DTC P0707 Transaxle Range Switch - Low Input: DTC Detecting Condition

DTC DETECTING CONDITION POSSIBLE CAUSE

Item	Detecting Condition	Possible cause
DTC Strategy	Check for No signal	Open or short in circuit Faulty TRANSAXLE RANGE SWITCH Faulty TCM (PCM)
Enable Conditions	Always
Threshold value	No signal detected
Diagnostic Time	More than 30sec
Fail Safe	Recognition as previous signal When P-D or R-D or D-R SHIFT is detected, it is regarded as N-D or N-R though "N" signal is not detected. When sports mode SAW is ON without P, R, N, D-RANGE signals, it is regarded sports mode. (DTC is not set)