Component Inspection

1. Ignition "ON" & Engine "OFF".
2. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode.
3. Using a scan tool, Clear DTC.
4. Using a "SCAN TOOL", Operate "LEARNING" Reset.
5. Perform the "LEARNING"
6. IG OFF <--> IG ON (Repeat 2~3times),and then Monitor the "DTC"
7. Is DTC Re-displayed ?

   YES 

   • Substitute with a known-good TCM and check for proper operation. If the problem is corrected, replace TCM as necessary and then refer to VERIFICATION OF VEHICLE REPAIR .

   NO 

   • Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Refer to COMPONENT INSPECTION .

METHOD OF LEARNING RESET 

* IT IS NECESSARY TO LEARNING RESET, AFTER REPLACED TRANSMISSION

1. ERASING CONDITION
   1. SELECT LEVER POSITION IS "P" OR "N"
   2. VEHICLE SPEED = 0km/h
   3. IGNITION "ON", ENGINE "OFF"
2. USING A SCAN TOOL, OPERATE "LEARNING" RESET
3. IG "ON" <--> IG "OFF" (2~3 TIMES), AFTER RESET