LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tucson GL, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle System) >> Service Adjustment Procedure >> Output Shaft Speed Sensor >> Replacement

Output Shaft Speed Sensor: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery and air cleaner, (see TRANSAXLE RANGE SWITCH REPLACEMENT )
  2. Remove the output shaft Speed sensor (A).
    Fig 1: Removing Output Shaft Speed Sensor, Output Shaft Speed Sensor Connector & Bolt
    G03763347Courtesy of HYUNDAI MOTOR CO.
    1. Disconnect the output shaft speed sensor connector (B).
    2. Remove the bolt (C).
    3. Inspect the output shaft speed sensor bore.
  3. Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.
  4. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals