Abs Does Not Operate

1. Connect the Hi-Scan (pro) with the data link connector and turn the ignition switch ON.
2. Verify that the normal code is output.

   Is the normal code output? 

Yes  : Go to next step

No  : Erase the DTC and recheck using Hi-Scan (pro).

1. Disconnect the connector from the ABS control module.
2. Turn the ignition switch ON, measure the voltage between terminal 4 of the ABS control module harness side connector and body ground.
   • Specification: approximately B+ 

Is the voltage within specification? 

Fig 1: Measuring Voltage Between Terminal 4 Of ABS Control Module Harness Side Connector And Body Ground

Courtesy of HYUNDAI MOTOR CO.

Yes  : Go to next step

No  : Check the harness or connector between the fuse (10A) in the passenger compartment junction block and the ABS control module. Repair if necessary.

1. Disconnect the connector from the ABS control module.
2. Check for continuity between terminals 8, 24 of the ABS control module harness side connector and ground point.

   Is there continuity? 

Fig 2: Checking Continuity Between Terminals 8, 24 Of ABS Control Module Harness Side Connector And Ground Point

Courtesy of HYUNDAI MOTOR CO.

Yes  : Go to next step.

No  : Repair an open in the wire and ground point.

Refer to the DTC TROUBLESHOOTING  procedures.

OK  : Go to next step.

NG  : Repair or replace the wheel speed sensor.

Refer to the hydraulic lines.

OK  : The problem is still occurring, replace the ABS control module.

NG  : Repair the hydraulic lines for leakage.