LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2003 >> Tiburon Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxles >> Overhaul >> Input Shaft >> Disassembly

Input Shaft: Disassembly

  1. Take off bearing using special tool (09527-4A000).
    Fig 1: Removing Bearing
    G00969054Courtesy of HYUNDAI MOTOR CO.
  2. Remove snap ring.
    Fig 2: Removing Snap Ring
    G00969055Courtesy of HYUNDAI MOTOR CO.
  3. Remove 6th gear, bushing, needle bearing and spacer using special tool (09457-34000).
    Fig 3: Removing 6th Gear, Bushing, Needle Bearing & Spacer
    G00969056Courtesy of HYUNDAI MOTOR CO.
  4. Pull out 5th gear and coupling assembly at the same time using special tool (09457-34000).
    Fig 4: Pulling Out 5th Gear & Coupling Assembly
    G00969057Courtesy of HYUNDAI MOTOR CO.
  5. Remove needle bearing and spacer.
  6. Pull out 3rd/4th gear and coupling assembly at the same time using special tool (09432-2C000).
  7. Remove the needle bearing and spacer.
    Fig 5: Removing Needle Bearing & Spacer
    G00969058Courtesy of HYUNDAI MOTOR CO.
  8. Pull out the input shaft front bearing.
scientia non olet · About LEMON Manuals