HOMELINK Programming: Programming

Your vehicles may require the ignition switch to be turned to the "ACC" position for programming and/or operation of HomeLink. It is also recommended that a new battery be replaced in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency.

Follow these steps to train your HomeLink mirror:

Fig 1: Pressing & Holding Two Outside Homelink Buttons

Courtesy of HYUNDAI MOTOR CO.

1. When programming the buttons for the first time, press and hold the two outside HomeLink buttons (1), (2) releasing when the indicator light begins to flash (approximately 20 seconds). This procedure erases the factory-set default codes. Do not perform this step when programming additional transmitters.
   Fig 2: Training Transmitter

   Courtesy of HYUNDAI MOTOR CO.
2. Hold the transmitter of the device you want to train 1 to 3 inches away from the bottom of the mirror. Simultaneously press the hand-held transmitter button and the HomeLink button you wish to train. The indicator light will flash slowly at first, then rapidly, indicating successful programming.
3. If the garage door opener or other device other device you wish to train is rolling-code equipped, proceed to the ADDITIONAL PROGRAMMING FOR ROLLING CODE DEVICES  .
4. Repeat step 2 to program the remaining HomeLink buttons.