General Information: General: Specifications
PROPELLER SHAFT
| Items | Specifications | |
|---|---|---|
| Length x O.D. mm (in.) | 2022 x 76.2 (79.6 x 3) | |
| Front | 967 x 76.2 (38 x 3) | |
| Rear | 1055 x 76.2 (41.5 x 3) | |
| Clearance Between Snap Ring & Groove | ||
| Wall of Yoke | 0.02-0.06 mm (0.0008-0.0024 in.) | |
| Runout | 0.5 mm (0.020 in.) or Less | |
|
NOTE:
Propeller shaft length indicates the length between the center point of each joint.
|
||
DRIVESHAFT
| Joint Type | 2.4L (M/T, A/T) | 2.7L (A/T) | Rear (4WD) | |
| Outer | B.J. | B.J. | B.J. | |
| Inner | T.J. | D.O.J. | D.O.J. | |
| Maximum permissible Joint Angle | ||||
| Outer | 46.5° | 46° | 46° | |
| Inner | 23° | 22° | 22° | |
| 4WD Type | Full Time Type Four Wheel Drive | |||
|
||||
HUB
| Limit | Specification |
|---|---|
| Hub End Play mm (in.) | 0.0008 (0.0003) or Less |
| Wheel Bearing Torque Nm (kg-cm, lb-in.) | 1.88 (18.8, 1.4) or Less |
DIFFERENTIAL
| Item | Specification |
|---|---|
| Reduction Gear Type | Hypoid Gear (7.0 in.) |
| Reduction Gear Ratio | 3.800 |
| Final Drive Gear Backlash mm (in.) | 0.08-0.13 (0.003-.0..5) |
| Differential Gear Backlash mm (in.) | 0-0.076 (0-0.003) |