Component Testing: Sub-Switch

NOTE: Sub-switch is incorporated into multifunction switch. If sub-switch is defective, multifunction switch assembly must be replaced.

Disconnect appropriate multifunction switch harness connector. Check continuity between appropriate switch terminals with switch in specified position. See SUB-SWITCH CONTINUITY . See Fig 1 or Fig 2 . If switch does not test as specified, replace multifunction switch.

SUB-SWITCH CONTINUITY

Switch Position

Continuity Between Terminals No.

SET/COAST

With EPS ⁽¹⁾

16 & 17

Without EPS ⁽¹⁾

6 & 10

RESUME/ACCEL

With EPS ⁽¹⁾

13 & 16

Without EPS ⁽¹⁾

7 & 10

⁽¹⁾	Electronic Power Steering (EPS).

Fig 1: Identifying Appropriate Multifunction Switch Connector (Without EPS)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Appropriate Multifunction Switch Connector (With EPS)

Courtesy of HYUNDAI MOTOR CO.