Hazard Warning Switch

Disconnect negative battery cable. Remove hazard switch. Disconnect hazard switch harness connector. Using ohmmeter, check continuity in each switch position, between indicated switch terminals. See HAZARD WARNING SWITCH TEST . SeeFig 1 . Replace switch if continuity is not as specified.

HAZARD WARNING SWITCH TEST

Switch Position

⁽¹⁾ Continuity Between Terminals No.

Off

2 & 3; 7 & 10

2 & 3; 5, 6 & 9; 7 & 8

⁽¹⁾	Terminals No. 2 and 3 are for illumination circuit.

Fig 1: Identifying Hazard Switch Harness Connector Terminals

Courtesy of HYUNDAI MOTOR CO.