Wiper Switch

Wiper/washer switch is incorporated within multifunction switch, mounted on steering column. Test continuity of wiper switch circuits with switch in position indicated in table. See WIPER/WASHER SWITCH CONTINUITY TEST .
Ensure continuity exists between terminals listed. Check connector and terminal cavity identification. SeeFig 1. For terminal descriptions, see MULTIFUNCTION SWITCH TERMINAL IDENTIFICATION .

Fig 1: Multifunction Switch Connector Terminal ID

Courtesy of HYUNDAI MOTOR CO.

WIPER/WASHER SWITCH CONTINUITY TEST ⁽¹⁾

Switch Position

Connector

Terminal Numbers

Off

"A"

2 & 8

Intermittent ⁽²⁾

"A"

2 & 8; ⁽²⁾ 9 & 13

Low

"A"

2 & 13

High

"A"

7 & 13

Washer

"A"

1 & 13

⁽¹⁾	Continuity should exist between terminals listed.

⁽²⁾	A resistor in circuit should fluctuate resistance between terminals No. 9 and 13.