LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 1986 >> Excel Base, 2D Hatchback >> Repair and Diagnosis >> Engine Performance >> Ignition System - Electronic >> Overhaul >> Disassembly >> Excel 1.5L

Excel 1.5L

  1. Remove distributor cap, rotor and seal. Remove governor assembly. Remove vacuum control unit. Remove IC ignitor. Remove lead wire. Remove signal rotor shaft screw and 2 breaker plate retaining screws. Remove breaker plate assembly.
    NOTE: DO NOT clean grease off back of IC ignitor. It is necessary for heat transfer.
  2. Remove signal rotor shaft from signal rotor. Remove 2 spring retainers and springs with pliers. Remove governor weights. Mark drive gear location on distributor shaft.
  3. Place drive gear on a wooden block and remove drive gear roll pin using a pin punch. Remove drive gear and washer. Remove distributor shaft from housing.
Fig 1: Installing Driven Gear on Distributor Shaft Align marks and install new roll pin.
G34230
scientia non olet · About LEMON Manuals