LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Engine Control System & Fuel System - 2.9L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (4) from the camshaft position (CMP) sensor (5).
    2. Fig 2: View Of Exhaust Camshaft Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor retaining bolt.
  3. Remove the CMP sensor from the cylinder head.

    Discard the O-ring seal.

scientia non olet · About LEMON Manuals