LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Multifunction Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: A new multifunction turn signal switch will come precentered with a centering tab attached. Do NOT remove the centering tab until installation is complete. Failure to follow procedure will cause a misalignment of the multifunction turn signal switch and centering will be required.
    If reusing the existing multifunction turn signal switch, you must center it. Refer to Inflatable Restraint Steering Wheel Module Coil Centering .
  1. Slide the multifunction turn signal switch onto the steering column.
    2. Fig 1: View Of Multifunction Switch/SIR Coil Assembly
    GM1488282Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the multifunction turn signal switch bolts.

    Tighten:  Tighten the bolts to 7 N.m (62 lb in).

  3. Route the wire harness assembly down the steering column.
    4. Fig 2: View Of Wire Harness Straps & Assembly
    GM1488252Courtesy of GENERAL MOTORS CORP.
  4. Connect any electrical connectors and install the wiring harness through any retainers as needed.
  5. Remove the centering tab from the multifunction turn signal switch.
  6. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  7. Install the steering wheel. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals