Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Install the steering column to the vehicle.
Perform the following procedure before installing the bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol, or equivalent, and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488).

Fig 1: View Of Steering Column

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the steering column bolts.
Tighten: Tighten the bolts to 27 N.m (20 lb ft).
Connect the upper intermediate steering shaft to the steering column. Refer to Upper Intermediate Steering Shaft Replacement .
If necessary, connect the range selector lever cable. Refer to Range Selector Lever Cable Adjustment (2.9L and 3.7L) or Range Selector Lever Cable Adjustment (5.3L) .
Connect any electrical connectors as needed.
Install the knee bolster. Refer to Knee Bolster Replacement .
Remove anti-rotation pin J 42640 .
Enable the SIR system. Refer to SIR Disabling and Enabling .