LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Linear Shift Assembly
    GM1492305Courtesy of GENERAL MOTORS CORP.
  1. Install the linear shift assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the linear shift assembly bolts.

    Move the linear shift assembly out of the PARK position temporarily to install the lower linear shift assembly bolt.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  3. Connect the automatic transmission shift lock actuator.
    4. Fig 3: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  4. Install the automatic transmission park lock cable (1).
  5. Install the shift lever. Refer to Shift Lever Replacement .
  6. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals