LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Cellular Systems, Entertainment Systems & Navigation Systems) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the mechanics wire to the end of the antenna cable.
    2. Fig 1: Locating Routing Hole Grommet
    GM1358256Courtesy of GENERAL MOTORS CORP.
  2. Pull on the mechanics wire to route the cable and grommet (1) through the hinge pillar.
    3. Fig 2: View Of Antenna Base & Screws
    GM1338048Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the screws retaining the antenna base.

    Tighten:  Tighten the screws to 7.5 N.m (66 lb in).

  4. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
    5. Fig 3: View Of Radio Extension Cable
    GM1363155Courtesy of GENERAL MOTORS CORP.
  5. Remove the mechanics wire from the antenna cable (1).
  6. Install the grommet to the hinge pillar.
  7. Connect the radio antenna cable (1) to the extension cable.
  8. Install the I/P compartment door. Refer to Instrument Panel Compartment Door Replacement .
  9. Install the right hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  10. Install the right front door sill plate. Refer to Front Side Door Sill Trim Plate Replacement .
scientia non olet · About LEMON Manuals