LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement (LH8) >> Removal Procedure

Removal Procedure

    Fig 1: Engine Wiring Harness Electrical Connector & Generator
    GM1897776Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  4. Disconnect the engine wiring harness electrical connector (1) from the generator.
  5. Reposition the engine wiring harness/positive battery cable boot (5).
  6. Remove the engine wiring harness/positive battery cable nut from the generator.
  7. Remove the engine wiring harness/positive battery cable (2) from the generator.
    8. Fig 2: Generator & Bolts
    GM899619Courtesy of GENERAL MOTORS CORP.
  8. Remove the generator bolts.
  9. Remove the generator.
scientia non olet · About LEMON Manuals