LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3T Base, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Bracket Replacement (LLR) >> Removal Procedure

Removal Procedure

    Fig 1: Engine Wiring Harness Electrical Connectors, Harness Bracket & Bracket Nut
    GM1897775Courtesy of GENERAL MOTORS CORP.
  1. Remove the generator. Refer to Generator Replacement (LLR)  or Generator Replacement (LH8) .
  2. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement .
  3. Remove the engine wiring harness bracket bolt (4).
  4. Reposition the engine wiring harness bracket out of the way.
  5. Disconnect the power steering gear inlet and outlet hose.Refer to Power Steering Gear Inlet and Outlet Hose Replacement (LH9) or Power Steering Gear Inlet and Outlet Hose Replacement (LLR)
    6. Fig 2: Generator Bracket & Bolts
    GM847280Courtesy of GENERAL MOTORS CORP.
  6. Remove the generator bracket bolts.
  7. Remove the generator bracket,with the power steering pump attached,from the vehicle.
  8. Transfer power steering pump.Refer to Power Steering Pump Replacement (LH9) or Power Steering Pump Replacement (LLR)
scientia non olet · About LEMON Manuals