LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Repair Instructions >> Outside Rearview Mirror Glass Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Motor/Actuator Ring To Actuator
    GM2260830Courtesy of GENERAL MOTORS CORP.
    NOTE: If the actuator ring is on the motor/actuator go to step 3. If the actuator ring is off do steps 1, 2.
  1. Install the motor/actuator ring (1) to the actuator (2), ensure that the actuator tabs (3) are in line with the motor/actuator ring.
    2. Fig 2: Placing Motor/Actuator Ring In Center Of Motor/Actuator
    GM2260831Courtesy of GENERAL MOTORS CORP.
  2. Place the motor/actuator ring (1) in the center of the motor/actuator (2), press inward until fully seated.
  3. Connect the electrical connectors to the mirror lens.
    4. Fig 3: Locking Mirror Glass Onto Retaining Tabs
    GM2260833Courtesy of GENERAL MOTORS CORP.
  4. Install the mirror lens as follows:
    1. Push the lower center of the mirror motor actuator ring inward.
    2. Position the mirror lens (1) on the mirror motor/actuator ring retaining tabs (2).
    3. Place your hand on the back of the mirror housing.
    4. Push downward on the top of the mirror glass (1) using a suitable tool until it is locks onto the retaining tabs (2).
    5. Remove the masking tape from the mirror housing.
  5. Inspect the mirror for proper operation.
scientia non olet · About LEMON Manuals