LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 3.7L - DTC P0335 To DTC P1381 >> DTC P0365 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the camshaft position sensor wire harness connector.
  2. Test for less than 1 Ω between the appropriate low reference circuit terminal B and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal A and ground.
    • If less than the specified range, test the 5 V reference circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Ignition ON, test for 4.8-5.2 V between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition OFF, connect a fused jumper wire to the camshaft position signal circuit terminal C.
  6. Ignition ON, momentarily touch the other end of the fused jumper wire to the battery negative post. The camshaft position active counter parameter on the scan tool should increment.
    • If the camshaft position active counter increments, replace the camshaft position sensor.
    • If the camshaft position active counter does not increment, replace the ECM.
scientia non olet · About LEMON Manuals