LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.
  1. Install the stabilizer shaft link.
    2. CAUTION: Refer to Fastener Caution .
    Fig 1: View Of Stabilizer Shaft Link Mounting Nut
    GM941489Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft link mounting nuts.
    • Tighten the stabilizer bar link lower mounting nut to 44 N.m (32 lb ft).
    • Tighten the stabilizer bar link upper mounting nut to 44 N.m (32 lb ft).
  3. Remove the axle support.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals