LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim System And Paneling) >> Repair Instructions >> Coat Hook Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coat Hook Retaining Screw
    GM1276795Courtesy of GENERAL MOTORS CORP.
  1. Position the coat hook over the retaining clip.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the screw and washer securing the coat hook to the retaining clip. Tighten the coat hook screw to 1.2 N.m (10 lb in).
  3. In replacing the entire coat hook assembly, press the coat hook and the retaining clip as an assembly into the sheet metal opening until the clip locks into position.
scientia non olet · About LEMON Manuals