LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
    GM360809Courtesy of GENERAL MOTORS CORP.
  1. Install the new stud into the hub flange hole using firm hand pressure.
  2. Install 4 washers to the new wheel stud.
  3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
  4. Tighten the lug nut until the stud contacts the back of the hub flange.
  5. Remove the wheel nut.
  6. Remove the washers.
  7. Install the brake rotor. Refer to Brake Rotor Replacement .
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Remove the safety stands.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals