LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Disc Brake System) >> Repair Instructions >> Disc Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a light coating of high temperature, silicone brake lubricant to the brake caliper guide pins.
    2. Fig 1: Brake Caliper Guide Pins & Seal
    GM2128792Courtesy of GENERAL MOTORS CORP.
  2. Install the upper brake caliper guide pin (1) and the upper brake caliper guide pin seal (2).
    3. NOTE: The lower brake caliper guide pin is equipped with a bushing and must be installed in the same location as removed.
  3. Install the lower brake caliper guide pin (3) and the lower brake caliper guide pin seal (4).
  4. Position the brake caliper to the brake caliper bracket.
    5. Fig 2: Brake Caliper Guide Pin Bolts
    GM2128791Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the brake caliper guide pin bolts (1) and tighten to 64 N.m (47 lb ft).
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals