LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Disc Brake System) >> Repair Instructions >> Brake Caliper Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Identifying Brake Hose & Fittings
    GM2128788Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not reuse the brake hose fitting gaskets.
  3. Remove the brake hose fitting bolt (1), the brake hose fitting gaskets (2), and the brake hose fitting (3) from the brake caliper.

    Cap the brake hose fitting to prevent brake fluid loss and contamination.

  4. Discard the brake hose fitting gaskets.
    5. Fig 2: Brake Caliper Guide Pin Bolts
    GM2128789Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake caliper guide pin bolts (1).
    6. Fig 3: Brake Caliper
    GM2128790Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake caliper (1).
scientia non olet · About LEMON Manuals