Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Dust Warning .

Fig 1: Wheel Speed Sensor Electrical Connector

GM2105755

Courtesy of GENERAL MOTORS CORP.

Within the engine compartment, disconnect the wheel speed sensor electrical connector (1).
Release the wheel speed sensor harness connector from the wheelhouse.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

Fig 2: Wheel Speed Sensor Harness Clips

GM2105757

Courtesy of GENERAL MOTORS CORP.

Release the wheel speed sensor harness clips (1) from the suspension upper control arm.

Fig 3: Wheel Speed Sensor Harness Grommet

GM2105762

Courtesy of GENERAL MOTORS CORP.

Release the wheel speed sensor harness grommet (1) from the mounting bracket.

Fig 4: Wheel Speed Sensor Harness Bracket Bolt

GM2105765

Courtesy of GENERAL MOTORS CORP.

Remove the wheel speed sensor harness bracket bolt (1).

Fig 5: Wheel Speed Sensor Bolt

GM2105767

Courtesy of GENERAL MOTORS CORP.

Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
Remove the wheel speed sensor bolt (1).

NOTE: Do not pry or lever against the wheel speed sensor to remove.

Fig 6: Wheel Speed Sensor

GM2106308

Courtesy of GENERAL MOTORS CORP.

Carefully remove the wheel speed sensor from the suspension knuckle by pulling straight upward.