LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Fixed And MOVEABLE Windows System) >> Repair Instructions >> Front Side Door Window Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
    3. Fig 1: View Of Front Door Window Retaining Bolts
    GM1350827Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolts retaining the front door window to the window regulator.
  4. Remove the front door window. Refer to Front Side Door Window Replacement .
    5. Fig 2: View Of Window Regulator Retaining Bolts
    GM1257630Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the window regulator motor, if equipped with A31.
  6. Loosen the bolts (1) retaining the window regulator to the inner panel at the keyhole slot locations.
  7. Remove the remaining fasteners retaining the window regulator to the inner panel.
  8. Remove the window regulator from the door by lifting the regulator up, and out of the keyhole slots, and removing the regulator out through the access hole.
scientia non olet · About LEMON Manuals