LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Roof Side Rail Module Replacement - Front (Regular and Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Retaining Bolts & Forward Curtain Clip
    GM1276902Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the 3 bolts (1) retaining the roof rail air bag module to the roof.

    Tighten:  Tighten the roof rail air bag module bolts to 9 N.m (79 lb in).

  2. Install a new forward curtain clip (2).
  3. Install the bolt (5) retaining the rear curtain to the roof.

    Tighten:  Tighten the roof rail air bag curtain bolts to 9 N.m (79 lb in).

  4. Install the rear tether bolt (3).

    Tighten:  Tighten the roof rail air bag rear tether bolt to 9 N.m (79 lb in).

    5. Fig 2: View Of Roof Rail Module Connector
    GM1276857Courtesy of GENERAL MOTORS CORP.
  5. Install the clips (3) to the pillar.
  6. Install the roof rail air bag forward tether bolt (3).

    Tighten:  Tighten the roof rail air bag forward tether bolt to 9 N.m (79 lb in).

  7. Connect the roof rail air bag electrical connector (1).
  8. Install the headliner. Refer to Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Regular Cab) or Headlining Trim Panel Replacement (Crew Cab) .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
  10. Install the head restraints from the front seats. Refer to Driver or Passenger Seat Head Restraint Replacement .
scientia non olet · About LEMON Manuals