LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3T Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Mirror System) >> Repair Instructions >> Rearview Mirror Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rearview Mirror Mounting Components
    GM787028Courtesy of GENERAL MOTORS CORP.
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
  2. Slide the base of the mirror onto the button.
    3. NOTE: Refer to Fastener Notice .
  3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.

    Tighten:  Tighten the screw (3) to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.

  4. Install the base trim cover.
    5. Fig 2: View Of Rearview Mirror Electrical Connector
    GM787027Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector.
  6. Install the wire cover.
  7. Reposition the mirror assembly.
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals