Section 3 (Automatic Transmission - Introduction)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Transmission Fluid Temperature Sensor Specifications
- Fastener Tightening Specifications
- Transmission General Specifications
- Fluid Capacity Specifications
- End Play Specifications
- Low and Reverse Clutch Spacer Plate Selection
- Forward Clutch Backing Plate Selection
- Third and Fourth Clutch Backing Plate Selection
- Reverse Input Clutch Backing Plate Selection
- Fluid Pump Rotor and Slide Measurement
- Torque Converter End Play Specifications
- 2-4 Band Servo Piston Pin Selection
- Range Reference
- Shift Solenoid Valve State and Gear Ratio
- Shift Speed
- Transmission Internal Mode Switch Logic
- Line Pressure
- Component Resistance
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures