Circuit/System Testing

Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and 15.0 V.
- If not within the specified range, refer to Charging System Test .
Ignition OFF, disconnect the harness connectors at the appropriate module.
Ignition OFF and scan tool disconnected, open and close the driver door, and wait 30 seconds. Test for less than 5 Ω between the appropriate ground circuit terminals listed below and ground.
- Terminal 9 (DRR)
- Terminal A12 X1 (Radio)
- Terminal B5 X1 (Radio)
- Terminal 7 X1 (VCIM)
- If greater than the specified range, test the ground circuit for an open/high resistance.
Verify that a test lamp illuminates between the appropriate B+ circuit terminal listed below and ground.
- Terminal 16 (DRR)
- Terminal B1 X1 (Radio)
- Terminal 16 X1 (VCIM)
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
If all circuits test normal, replace the appropriate module.