LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement

Ignition and Start Switch Replacement

Fig 1: Ignition and Start Switch Replacement
GM1749570Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Disable the supplemental inflatable restraint system. Refer to SIR Disabling and Enabling .
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the lower steering column shroud. Refer to Steering Column Shroud Replacement .
1 Ignition and Start Switch Electrical Connector
2 Ignition and Start Switch Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  0.74 N.m (7 lb in)
3 Ignition and Start Switch
Procedure: 
Turn the ignition lock cylinder to the run position prior to removing the ignition and start switch.
scientia non olet · About LEMON Manuals